Product Description

Eliminates the need to disconnect the battery from the terminals while welding on a vehicle. Simply clip on the Antizap Surge protector and you're ready to weld. Protects sensitive electronics, reduces labor time, and pays for itself after one or two uses.

• Protects vehicle electronics during MIG, TIG, or Argon Arc welding
• Fully insulated booster clamps with 2-function Antizap protection
• Eliminates the time needed to disconnect the battery
• Just clip the clamps across the battery and the green LED indicates complete electrical system protection
• Available in 12 volt and 24 volt models

32-020

Antizap Clamp-on surge protection 12 volt

32-030 *Pictured

Antizap Clamp-on surge protection 12/24 volt

32-040

Antizap Permanent mount 24 volt

32-050

Antizap Permanent mount 12 volt

Warning

Ensure vehicle is correctly grounded before welding. The Antizap Surge Protector will not protect against induced current created by incorrect welding procedures. Always follow manufacturer's instructions. Additional Antizap surge protection may be required for accessories wired into the vehicle's wiring harness between the point of weld and the battery. If in doubt, see the advice of an electrician prior to welding. Goodall® Mfg.'s warranty is limited to the replacement of a defective product. Goodall® shall not be liable for any consequential or incidental damages.